Pppoe (Point-To-Point Protocol Over Ethernet) - EnGenius ESR-9710 User Manual

Wireless n gigabit router

Hide thumbs Also See for EnGenius ESR-9710:

Table of Contents

ESR-9710 Wireless N Gigabit Router

Version 1.0

3.1.2 PPPoE (Point-to-Point Protocol over Ethernet)

The WAN interface can be configured as PPPoE. This type of connection is usually

used for a DSL service and requires a username and password to connect.

Select the Username / Password Connection (PPPoE) radio button and then click

on the Next button.

Address Mode: PPPoE can be used with a dynamic or static IP address. If you

select the Dynamic IP radio button, then the IIP address in the next field is not

required. However, if you select the Static IP radio button, then the IP address in the

next field is required.

User Name: Specify the user name which is provided by your ISP.

Password: Specify the password which is provided by your ISP, and then verify it

once again in the next field.

Service Name: Specify the name of the ISP.

Click on the Next button to continue.

Table of Contents