COZY BBT54 Installation And Operation Instructions Manual page 10

INSTALLATION - Cont'd.
24 V.
Thennostat
When wiring more than one baseboard heater to a single thermostat, the baseboard heaters must be wired in
PARALLEL. When wiring more than one baseboard heater to a single 24 VAC thermostat, the baseboard
heaters must be hard wired in parallel. Do not use cord sets. Do not cross thermostat connections between
heaters. Purple thermostat connection from first heater to purple thermostat on second and third heater. Do the
same with white thermostat connection.
FIGURE 10
The anticipator setting on the thermostat should be equivalent to the current draw of the total number of
valves being controlled.
NUMBER OF BASEBOARD HEATERS ANTICIPATOR SETTING
1 .1 AMP
2 .2 AMP
3 .3 AMP
STEP 7. COMPLETING INSTALLATION
a) Connect gas supply line to flex gas line/shut-offvalve from heater.
b) Turn gas supply on. Check connections with soapy solution.
c) Plug power cord into grounded 115 V. outlet or turn power on if hard wired.
d) Replace cabinet cover and secure with three screws at bottom.
Heater is now installed, follow lighting instructions to put heater in operation.
During initial warm-up the heater may smoke slightly. Provide adequate ventilation should this occur.
Page l0