Increasing the Memory
2
Remove the four screws.
≥ These screws are used in step 2 of the
"Installing the interface board."
3
Remove the interface board by pulling
on the handle.
≥ Be sure not to insert your hand into the
unit when removing the interface board.
Injury may result.
¥ Installing the DIMM module
Insert the DIMM module into the connector on
the interface board (1), then push it until it clicks
into place.
NOTE:
≥ Be sure that the module notch is to the left side, or
the DIMM module will not be in the proper position.
≥ To remove the DIMM module, pull the tabs at both
sides of the connector.
≥ Do not touch any electrical components on the
surface of the board to avoid static electricity.
20
Handle
DIMM
Connector
Tab
Tab