Hardware Installation Guide; Setting Up; Power Supply Installation - Antec Six Hundred User Manual

H I
ARDWARE NSTALLATION
2.1 S U
ETTING P
1. Place the case upright on a flat, stable surface with the
rear of the case facing you.
2. Remove the side panels by first removing the
thumbscrews at the rear of the case. Then, grip each
panel at the top and bottom and slide it toward the rear
of the case until it detaches from the chassis.
3. To remove the front bezel, depress the tabs on the left
side of the inside of the front bezel, then swing the bezel
open. Once open, it will detach easily from the chassis.
Note: Do not use your fingernails to pry or lift the panels.
2.2 P S I
OWER UPPLY NSTALLATION
1. With the case upright, place the power supply on the
bottom of the case.
Note: Power supplies with fans on the bottom of the
power supply will need to be mounted so that the
fan is facing the top of the case. The Six Hundred
provides mounting holes for power supplies with
standard mounting layouts to be installed right-
side-up or upside down.
2. Push the power supply to the back of the case and align
the mounting holes.
3. Attach the power supply to the case with the screws
provided.
G
UIDE
4