Optional Fans - Antec Six Hundred User Manual

4.3 O F
PTIONAL ANS
There are a total of three optional 120mm fan mounts—one side intake fan (on the left side panel) and
two front intake fans (at the front of the HDD cage). We recommend using Antec 120mm speed control
fans and setting the speed to Low. These fans must be installed so that the air is blowing into the case.
Side Fan – The side fan enhances graphic cards cooling.
The fan should be installed so air is blowing into the case.
To install the side fan:
1. Remove the windowed side panel as described in
section 2.1, and take two silicone grommets from
the tool box.
2. Attach the silicone grommets to the two
compatible holes in the fan mount. Squeeze the
shorter end of the grommets into the apertures
until they lock into position.
3. Secure your 120mm fan to the two silicone
grommet mounts with the included screws on the
inside of the side panel. The fan should be
installed so that air is blowing into the case.
Front Fans – You can install two 120mm fans to the fan cages
in front of the hard drive bays. To install the front fans:
1. Remove the front bezel as described in section 2.1.
2. Depress the two tabs on the right side of the black fan
holder and swing it outward. The holder will easily pull
free of the chassis.
3. Secure your 120mm fan(s) to the fan holder with the
provided screws. The fan should be installed so that air
is blowing into the case.
4. Reattach the fan holder to the case by inserting the
right side into the corresponding slots on the front of
the case, then rotating the holder back into position
until it clicks into place.
Note: In order to build a quieter system, Antec recommends NOT installing the optional fans unless
it is necessary for cooling. If you choose to install them we recommend using Antec 120mm
TriCool™ fans and setting the speed to Low.
12