Materials Needed - Amana ASD2326HEB Use & Care Manual

Table of Contents

Advertisement

Available languages

Available languages

Materials
Needed
¼" outer diameter flexible copper tubing
Shut-off valve (requires a '/4" hole to be drilled into
water supply line before valve attachment}
Adjustable
wrench
'/4" hex nut driver
Add 8' to tubing
length needed to reach water
supply for creation of service loop.
1. Create service loop with copper
tubing
(minimum
2' diameteO.
Avoid kinks in the copper tubing
when bending the service loop.
2. Remove plastic cap from water valve
inlet port.
3. Place brass nut (A} and
sleeve (B} on copper
tube end as illustrated.
(Do not use old sleeve.}
A
4. Place end of copper tubing
into water
valve inlet port. Shape tubing slightly. Do
not kink - so that tubing feeds straight
into inlet port.
5. Slide brass nut over sleeve and screw nut
into inlet port. Tighten nut with wrench.
IMPORTANT:
Do not overtighten.
Cross
threading
may occur.
6_
Pull on tubing to confirm
connection
is
secure. Connect tubing
to frame with
water tubing
clamp (C} and turn on
water supply. Check for leaks and
correct if necessary. Continue to
observe the water supply connection
for two to three hours prior to moving
the refrigerator
to its permanent
location.
7. Monitor water connection
for 24 hours.
Correct leaks, if necessary.
Handme installation
If not installed, the handle is located in the interior of
the fresh food section or attached to the back of your
refrigerator.
Remove and discard handle packaging
and tape.
Handle design varies from refrigerator
to refrigeratoL
Please reference the appropriate
instructions
for your
model below.
Front Mount
Handle
MateriaJs
Needed
Gloves to protect hands
Phillips screwdriver
Plastic door removal card (or %" thick plastic card},
retain the card
To Install:
The handles are to be oriented
as shown.
AJign front mount door handle
dip with the door tabs.
Ensure the handle dips are
positioned
sJightJy above the
door tabs.
3lip
Door
Tab
4. Rotate the handle so that the
handle is fiat against the door.
5, Push the handle down against the
upper door tab just enough to allow
it to hang unsupported.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents