Advertisement
Available languages
Available languages
7.
Opengrass catchercover by pushingin on the rear,right-sidetab
with yourright-hand,as seenin 1 of Fig. 4-15,and lifting with your
left-handin the rear center,2.
Figure 4-15
8.
Installbothgrass binsontothe bin supportassemblyby inserting
thefront edge in first (1),as seenin Fig. 4-16,and settingthe
backedge down(2) until it fits intothe assembly.
NOTE:The sideof the grass binswith the tight mesh isintendedto be
positionedfacingforward.
10. Install t hedeck mounting pin (711-05049) up intothechuteelbow
usingtheflatwasher(736-3092) f romhardware pack689-00092 and
securewitha flangelocknut(712-04064), as seenin Fig.4-17.
f
11.
12.
Figure4=17
Install t heshoulder b olt(738-0754) i ntothechuteelbowfromthetop
sideandsecureinsidethechuteelbowusinga flangelocknut(712-
04063)fromthe samehardware pack(689-00092). S eeFig.4-17.
Install t hegrass-catcher p in(711-04069) fromhardware pack689-
00092intotheholeprovided in the upperportionofthechuteelbow
and secure witha flangelocknut(712-04064). See Fig.4-18.
®
.
Figure 4=16
Install o neof therubberchutestraps(723-04008A) ontothe
discharge chuteelbowusingoneof thesupplied clevispins(711-
05063),washer(736-0204) a nd Bow-tie cotterpins(714-04040)
fromhardware pack689-00092. S eeFig.4-17.Securetheendof
thestraputilizing theholefurthest f romtheend,and insertthetorsion
springhook(732-04510A)from thesamehardware packintothe
otherendofthe rubber strap.
Figure4=18
12
Advertisement
