Advertisement
Quick Links
Advertisement
Related Manuals for Encore ENHGS-800
Summary of Contents for Encore ENHGS-800
-
Page 1: User Guide
ENHGS-800 GIGABIT 8-PORT ETHERNET SWITCH User Guide... - Page 2 FCC Certifications This Equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
- Page 3 CPU usage. The switch is plug-n-play without any software to configure and also fully compliant with all kinds of network protocols. Before you start to install the switch, check the following contents in this package： One Gigabit Ethernet switch...
- Page 4 Please refer to the following table for LED definition 5-Port 8-Port Status Operation Power Steady Green Power is on Power is off 1000M Steady Green Connected as 1000Mbps Blinking Green The port is transmitting/receiving data. 100M Steady Green Connected as 100Mbps Blinking Green The port is transmitting/receiving data.
- Page 5 Connect each station to the switch by twisted-pair cable. Plug one RJ-45 connector into a RJ-45 port of the switch, and plug the other RJ-45 connector into the station’s network adapter. Power on the switch and then system is ready.
- Page 6 Standard IEEE 802.3 10BASE-T IEEE 802.3u 100BASE-TX IEEE 802.3ab 1000BASE-T IEEE 802.3x full duplex operation and flow control Interface 5/ 8* 10/100/1000Mbps RJ-45 Gigabit Ethernet Ports Uplink Auto MDI/MDI-X（Auto crossover） Network 10/100/1000Mbps & Full/Half duplex mode auto Speed detection (1000Mbps for Full duplex only) MAC Addr.