Nvram (Non-Volatile Memory); Bar Code Printing - Epson T88IIIP - TM B/W Thermal Line Printer Technical Reference Manual

Note:
When DIP SW2-1 is ON, the printer will not become BUSY even if printer hardware stops operating.
•
When an error has occurred
•
When the cover is open
•
When printing has stopped for a paper out
•
When paper is fed by the paper FEED button

3.5 NVRAM (Non-volatile Memory)

NVRAM is mounted on this printer, and bitmap images (for example, business logos) or other
data are written to it. Pay attention to the following when using NVRAM.
❏ The following restriction applies when performing operations (including storing and
deleting data) in NVRAM.
• Do not use the paper FEED button.
❏ The printer sometimes enters the BUSY state when data is being written to NVRAM. It is
important not to send data from the host computer while the printer is in the BUSY state,
because the printer cannot process any received data.
❏ Frequent use of the functions for writing data to and deleting data from NVRAM may
damage the memory. As a rule, in using the various commands to write to NVRAM, avoid
writing more than an average of ten times per day.

3.6 Bar Code Printing

This printer can print the following types of bar codes:
UPC-A, UPC-E
JAN 8 (EAN 8), JAN 13 (EAN 13)
CODE 39
ITF (Interleaved 2 of 5)
CODABAR (NW-7)
CODE 93
CODE 128
To set and print each bar code, refer to the OPOS, Advanced Printer Driver, and ESC/POS
command documentation, respectively.
3-12 Application Development Information Rev. A