Dip Switch Functions - Epson T88IIIP - TM B/W Thermal Line Printer Technical Reference Manual

2. Unscrew the screw to remove the DIP switch cover from the base of the printer.
3. Set the DIP switches as desired, using the tip of a tool, such as a small screwdriver.
4. Attach the DIP switch cover, and screw in place.
Note:
New DIP switch settings are enabled after the printer is turned on.

2.2.2 DIP Switch Functions

The DIP switch functions depend on your printer's interface specifications.
2.2.2.1 DIP switch settings for serial interface specifications
Note that the functions of DIP SW1-7, 1-8, and 2-5 differ on the TM-T88II and TM-88III. (The
functions of other DIP switch settings are the same.)
Note:
* Factory setting
Table 2-1 Switch bank 1 settings
SW Function
1-1 Data receive error
1-2 Receive buffer size
1-3 Handshake
1-4 Bit length
1-5 Parity check
1-6 Parity selection
,
1-7 Baud rate selection
1-8 (See the "Baud rate selection" tables below. (Note that the settings differ on the TM-T88II and TM-T88III.))
For details on DIP SW1-2: Receive buffer size, also refer to DIP SW2-5: Cancellation of receive buffer full BUSY state.
Rev. A
Figure 2-2 Removing the DIP switch cover
TM-T88II/T88III Technical Reference Guide
DSW1
DSW2
ON
Ignore
45 bytes
XON/XOFF
7 bits
Yes
Even
OFF
"?" is printed *
4KB *
DTR/DSR *
8 bits *
No *
Odd *
Setup 2-3