GE Monogram ZKD910 Owner's Manual page 7

Using the Warming [)rawer
• . y Ele(:tIJ(: l,_arm_ng Drawer
Control
knob
The warming drawer controls are hidden with
the drawer shut. Open the drawer. The controls
are on the right side of the fl'ont fl'ame.
To use the warming drawer, press the ON/OFF
switch to the ON position,
Slide the moisture selector control to the open
or closed setting, (See the Moisture Selector
section.)
Turn the control knob clockwise to the desired
settin ,
PROOF ... 75-95°E MED ..... 160-195°E
LOW ..... 140-160°E HIGH .... 195-230°E
PROOF
0
• MED
HI
Q
LO
ONsignal
li#zt
The ON signal light is located below the
ON/OFF switch and glows when the ON/OFF
switch is in the ON position. It stays on until the
ON/OFF switch is moved to the OFF position.
The ON signal light is visible through the light
viewer in the drawer f/"ont panel when the
drawer is closed. This is a reminder that the
heat is on.
Moisture
selector
The moisture selector is located on the inside
fl'ont of the drawer.
To keep foods moist, slide the moisture selector
control awav fl'om the control knob. This closes
the vent and seals the moisture inside the
drawer, With the vent closed hot fi)ods stay
moist and soft.
In this setting condensation mav occur around
the inside edge of the drawer.
To keep foods crisp, slide the moisture selector
control to the right towards the control knob.
This opens the vents and allows the moisture
to escape.
With the vents open, it is normal tot moisture to
collect on surtaces above the warming drawer.
Additional
pans
An access(n') pan kitJXPN2 is available from
(;E at extra cost.
Two pans with lids (4" deep)
• One lar,*e_,pan (14 quarts)
• One medium pan (6 quarts)