GE Monogram ZKD910 Owner's Manual page 12

Before You (;all For Service...
El¢_t*i_ 14_*mingDrawcr
Save time
and money.*
Review the
troubleshooting
tips on this
page first and
you may
not
need to cag
./br service.
PROBLEM POSSIBLE CAUSE
WARMING DRAWER
WILL NOT WORK
DRAWER DOES NOT
SLIDE SMOOTHLY
OR DRAGS
FXCESSIVE
CONDENSATION
* A fuse in your home mav be blown or the circuit breaker tripped.
Replace the fuse or reset the circuit breaker.
* _%_rming drawer not plugged in. Plug in.
* _%u'ining drawer controls improperly set. See the Using the
_u'ming Drawer section.
* Ball bearings are out of alignment. Fully extend the drawer and
push it all the way in. See the Care and Cleaning section.
* Drawer ore>loaded or load unbalanced. Reduce weight to less than
50 pounds. Redistribme drawer contents.
Liquid in warming drawer. Remove liquid.
Uncovered foods. Cover food with lid or aluminum fl_il.
®
o
o
®
NO HEAT IN THE *
PRO OF SETTING
FOOD DRIES OUT * Moisture escaping. Coxer food with lid or ahuninum foil.
Temperature setting too high. Reduce temperature setting.
Incorrect Moisture Selector setting. Set the Moisture Selector to
the open vent setting to allow venting.
Room temperature may prevent the thermostat fl'om tripping on.
Turn the knob to LOW then back to PROOE
12