Step 4: Configure Time Settings (Tz And Time) - Motorola SV-4250-P-1 - AirDefense Enterprise Appliance 4250 Quick Installation Manual

Appliance Quick Installation Guide
10
3. Type the default Command Line User password (smxmgr), and then press <Enter>.
ADSPadmin
The
4. Go to the next step: Configure Time Settings.

3.4 Step 4: Configure Time Settings (TZ and Time)

To configure time settings for your ADSP appliance, you can either:
• Specify the time zone and time.
• Specify an NTP server.
Alternative A: Specify the time zone and time
1. Type tz at the prompt, and then press <Enter>.
The Time zone screen displays a list of global regions.
2. Type the number that corresponds to your region name, and then press <Enter>.
A message displays to confirm your selection. You are also alerted that committing to
this change will reboot your system when you exit ADSPadmin.
3. Type yes to save your changes, and then press <Enter>.
4. Type time at the prompt, and then press <Enter>.
The CLI displays the current settings for date and time.
5. Type the date in MMDDYYYY format, and then press <Enter>. Do not use colons or
forward slashes.
6. Type the time in 24-hour HHMM or HHMMSS format, and then press <Enter>.
7. Type yes to save your changes, and then press <Enter>.
Config
The
reboot.
8. Go to the next step: Configure the IP Address.
Alternative B: Specify an NTP Server
1. Type ntp at the prompt, and then press <Enter>.
The NTP screen displays, indicating whether NTP is currently enabled.
2. Type e to enable NTP, and then press <Enter>.
main screen displays.
CAUTION Changing the time settings later, after AirDefense accumulates data,
can have an adverse effect on the integral state, time, and event
associations that are essential to accurate data reporting.
screen displays. Do not exit ADSPadmin. This will cause the system to