Step 5: Configure The Ip Address (Ip) - Motorola SV-4250-P-1 - AirDefense Enterprise Appliance 4250 Quick Installation Manual

3. Type the IP address or Fully Qualified Domain Name of the NTP server you want this
appliance to use, and then press <Enter>.
4. Type yes to save your changes, and then press <Enter>.
Do not exit from ADSPadmin. This will cause the system to reboot.
5. Go to the next step: Configure the IP Address.

3.5 Step 5: Configure the IP Address (IP)

Set the IP address, subnet mask, and gateway of the ADSP appliance. DHCP is enabled by default.
1. At the command prompt on the
Config
The
IP
2. Type at the prompt, and then press <Enter>.
The IP address config screen displays. The screen displays the current network
configuration.
3. Type a new IP address, and then press <Enter>.
4. Type a new subnet mask, and then press <Enter>.
ADSPadmin
screen displays.
c
main screen, type , and then press <Enter>.
Installation Steps 11