Log Placement - White Mountain Hearth LS-18P-1 Installation Instructions And Owner's Manual

Before you begin: Do not, handle these logs with your bare hands! Always wear gloves to prevent skin irritation. After handling logs,
wash your hands gently with soap and water.
All Logs
The positioning of the logs is critical to the safe and clean operation of this heater. Sooting and other problems may result if the logs are
not properly and firmly positioned in the appliance.
Refer to Figure 1 for the following warning.
Warning: Failure to position the parts in accordance with this diagram or failure to use only parts specifically approved with this
appliance may result in property damage or personal injury.
PROPER INSTALLATION SEQUENCE:
LS-(18, 24, 30)P
(Figures 1 to 5)
1. Place front left (A) log onto burner pan pins.
2. Place rear left (B) log between rear log support and front left log (A)
3. Place rear right (C) log between rear log support and burner pan, resting on right side of burner pan.
4. Place right front (D) log onto pins on burner pan.
5. Place rear center (E) log onto left pin of rear log support.
6. Place boss on middle left (F) log into recess on rear left (B) log and left front (A) log.
7. Place middle right (G) log onto the right pin of rear log support and resting on rear right (C) log.
Page 4

LOG PLACEMENT

B
A
F
B
A
C
Figure 1
E
C
Figure 2
D
G
D
20176-3-0107