Log Placement - White Mountain Hearth ROCK CREEK LSU18RR-2 Installation Instructions And Owner's Manual

Before you begin: Do not, handle these logs with your bare hands! Always wear gloves to prevent skin irritation. After handling logs,
wash your hands gently with soap and water.
All Logs
The positioning of the logs is critical to the safe and clean operation of this heater. Sooting and other problems may result if the logs are
not properly and firmly positioned in the appliance.
refer to Figures 1 through 3 for the following warning.
warning: Failure to position the parts in accordance with this diagram or failure to use only parts specifically approved with this
appliance may result in property damage or personal injury.
PrOPer INSTALLATION SeQueNce:
ATTENTION: For the instructions below, "Front" indicates the side of the burner with the valve.
1. With the valve "front" side facing you, place Back Right Log (log A) onto right back pins of burner.
2. Place Right Middle Log (log B) onto right middle pins of burner.
3. Place Left Back Log (log C) onto left back pins of burner.
4. Place Left Middle Log (log D) onto left middle pins of burner.
5. Place Right Front Log (log E) onto right front pin of burner.
6. Place Center Middle Log (log F) onto burner top against logs B and D. Note: Omit this step for 18" log sets.
7. Place Left Front Log (log G) onto left front pins of burner.
8. Insert boss of Middle Bottom Branch (log H) into recess on logs E, B, and C.
9. Insert boss of Middle Top Branch (log I) into recess on log H (Middle Bottom Branch) and logs A and B. Note: Omit this step for
18" log sets.
10. Insert boss of Top Left Branch (log K) into recess on logs C, D, and G.
11. Insert recess of Top Right Branch (log L) into the recess on log A.
12. Compare the completed log installation with Figure 4. Review previous steps to make any necessary adjustments.
13. Log placement is complete.
NOTe: When placed correctly, the logs will not cover any ports.
25742-0-0309

LOG PLACEMENT

Figure 1 Figure 2
Page 5