Log Placement - White Mountain Hearth LS-18H-1 Installation Instructions And Owner's Manual

Before you begin: Do not, handle these logs with your bare hands! Always wear gloves to prevent skin irritation. After handling logs,
wash your hands gently with soap and water.
All Logs
The positioning of the logs is critical to the safe and clean operation of this heater. Sooting and other problems may result if the logs are
not properly and firmly positioned in the appliance.
Refer to Figure 1 for the following warning.
Warning: Failure to position the parts in accordance with this diagram or failure to use only parts specifically approved with this
appliance may result in property damage or personal injury.
PROPER INSTALLATION SEQUENCE:
LS-(18, 24, 30)H
(Figure 1)
1. Place rear (#2) log between rear log support and onto burner
pan pins.
2. Place front (#1) log onto pins on burner pan.
3. Place top log (#3) onto (2 pins) front log.
4. Compare the completed log installation with the appropriate
photo from pages 5 through 7. Review previous steps to make
any necessary adjustments.
5. Log placement is completed.
Attention: Do not use Figure 1 to order replacement logs. Refer to
Page 8, Parts List and Parts View to order logs for your appropriate
model number.
Apply loose material (glowing embers) per appropriate Installation
Instructions and Owner's Manual. Replacement of loose material
(glowing embers) must be purchased from Empire Comfort
Systems, Inc. Application of excess loose material (glowing
embers) may adversely affect performance of the heater.
WARNING: All previously applied loose material must be
removed prior to reapplication.
Replacement Loose Material (glowing embers) Part
Number
LS-18H
LS-24H
LS-30H
Platinum Bright Embers PE-20-1
Note: A single layer of embers is to be used when applying
Platinum Bright Embers (alone or in combination with production
embers) to the burner.
Page 4

LOG PLACEMENT

15999
15970
15970
Log Placement
LS-(18, 24, 30)H Logs
The following WARNING applies when log set is installed onto
an unvented gas burner assembly.
WARNING: This appliance is equipped for (natural or
propane) gas. Field conversion is not permitted.
2
3
Figure 1
20173-1-0506
1