Brother MFC 8890DW - B/W Laser - All-in-One User Manual page 157

Error Message
Out of Memory
Print Unable XX
Protected Device
Rename the File
Replace Parts
Drum
Replace Parts
Fuser Unit
Cause
The machine's memory is full.
The machine has a mechanical
problem.
The protect switch of the USB
Flash memory drive is on.
There is already a file on the USB
Flash memory drive with the
same name as the file you are
trying to save.
The drum unit is the end of its life. Replace the drum unit.
The drum unit counter was not
reset when a new drum was
installed.
It is time to replace the fuser unit. Call Brother Customer Service to replace the
Troubleshooting and routine maintenance
Action
Fax sending or copy operation in
progress
Do one of the following:
Press Start to send or copy the scanned
pages.
Press Stop/Exit and wait until the other
operations in progress finish, and then try
again.
Clear the data from the memory. (See
Out of memory message on page 47 or
page 92.)
Print operation in process
Do one of the following:
Reduce print resolution. (See Advanced
tab in the Software User's Guide on the
CD-ROM.)
Clear the faxes from the memory. (See
Out of memory message on page 92.)
Disconnect the machine from the power for
several minutes, then reconnect it. (The
machine can be turned off for approximately
60 hours without losing faxes stored in the
memory. See Transferring your faxes or Fax
Journal report on page 144.)
Turn off the protect switch of the USB Flash
memory drive.
Change the file name of the file on the USB
Flash memory drive or the file you are trying
to save.
(See Replacing the drum unit on page 163.)
1 Open the front cover, and then press
Clear/Back.
2 Press 1 to reset.
fuser unit.
1-877-BROTHER (1-877-276-8437) (in U.S.A)
1-877-BROTHER (in Canada)
C
141