Brother MFC 8890DW - B/W Laser - All-in-One User Manual page 156

Error Message
Document Jam
DR Mode in Use
Drum Error
Duplex Disabled
Fuser Error
Jam Duplex
Jam Rear
Jam Inside
Jam MP Tray
Jam Tray 1
Jam Tray 2
No Paper
No Response/Busy
No Toner
No Tray
140
Cause
The document was not inserted
or fed properly, or the document
scanned from the ADF was too
long.
The machine is set to Distinctive
Ring mode. You cannot change
the Receive Mode from Manual to
another mode.
The corona wire on the drum unit
needs to be cleaned.
The drum unit has reached the
end of its life.
The duplex tray is not installed
properly.
The temperature of fuser unit
does not rise at a specified
temperature within specified time.
The fuser unit is too hot.
The paper is jammed in the
duplex tray.
The paper is jammed in the back
of the machine.
The paper is jammed inside the
machine.
The paper is jammed in the MP
tray of the machine.
The paper is jammed in the paper
tray of the machine.
The machine is out of paper or
paper is not properly loaded in the
paper tray.
The number you dialed does not
answer or is busy.
The toner cartridge or the drum
unit and toner cartridge assembly
is not installed properly.
The paper tray is not completely
closed.
Action
See Document jams on page 145 or Using
the automatic document feeder (ADF)
on page 20.
Set Distinctive Ring to Off. (See Turning off
distinctive ring on page 57.)
Clean the corona wire on the drum unit. (See
Cleaning the corona wire on page 156.)
Replace the drum unit. (See Replacing the
drum unit on page 163.)
Remove the duplex tray and install it again.
Turn the power switch off, wait a few
seconds, and then turn it on again. Leave the
machine for 15 minutes with the power on.
The machine can be turned off for
approximately 60 hours without losing faxes
stored in the memory. (See Transferring your
faxes or Fax Journal report on page 144.)
(See Paper jams on page 147.)
(See Paper jams on page 147.)
(See Paper jams on page 147.)
(See Paper jams on page 147.)
(See Paper jams on page 147.)
Do one of the following:
Refill the paper in the paper tray or MP
tray.
Remove the paper and load it again.
Verify the number and try again.
Re-install the toner cartridge or the drum unit
and toner cartridge assembly.
Close the paper tray properly.