Power Outage - GE JGB900 Owner's Manual & Installation Instructions

Usingthe oven.
Toavoid possible bums, place the shelves in the desired position before you turn the oven on.
Before you begin...
The shelves have stop-locks, so that when
placed correctly on the shelf" supports (A
through E), the_ will stoI ) before confing
completely ()tit, and will not flit.
X,\qmn placing and remo_im,_ cookware,
pull the shelf out to the bump on the shelf
support.
To remove a shelf, pull it toward you, tilt the
fl'ont end up and pull it out.
To replace, place the end of the shelf (stoi>
locks) on the support, flit up the fl'ont and
push the shelf in.
NOTE: Theshelf is not desl)ned to slide out at the
special low shelf (R)position.
The oven has 5 shelf positions.
It also has a special low shelf
position (R)for extra large items,
such as a large turkey.
Plastic items on the cooktop may
melt if left too close to the vent.
Vent appearance and location varg
Oven Vent
Your oven is vented through ducts at the
rear of the range. Do not block these ducts
when cooking in the oven--it is important
that the flow _ff hot air ti'om the oven and
fl'esh air to the oven bm'ner be
tminterrui)ted. Avoid touching the vent
openings or nearby sm'fi_ces dm_ing oven or
broiler operation--they may become hot.
!;>Handles of potsandpanson thecooktop may
become hot if lefi toocloseto thevent
iJi:: D o not leave plastic or flammable items on the
cooktop--they may melt or ignite if left too close
to the vent
iJi:: D o not leave closed contalbers on the cooktop.
Thepressure lb closed contalbers may increase,
which may cause them to burst.
iJi:: Metal itemswill become very hot if theyareleft
on thecooktop, a ndcouldcause bums.
Power Outage
CAUTION: D onotmakeanyattemptto operatethe
electricignitionovenduringan electrical power
failure.
The oven or broiler cmmot be lit dm_ing a
power fidlm'e. (;as will not flow tmless the
glow bar is hot.
If the oven is in use when a power fifilm'e
occm_, the oven burner shuts off and
cmmot be re-lit tmtil power is restored. This
is beca use the flow of gas is a utomaflcallv
stopped and will not resume when power is
restored
tmtil the glow bar has reached
operating temperature.
Oven Light
Touch the OVEN LIGHTpad on the upper
control panel to mrn the light on or off'.
On some models, the OVEN LlOHTswitch is
on the lower fl'ont control panel.
12