GE JGB900 Owner's Manual & Installation Instructions page 49

Installation instructions
[] INSTALLING THE ANTI-TIP
DEVICE
A WARNING!
• R'm,,e, _ must be secured with an approxed Anti-
Tip dexice.
• Unless properly installed, the range could be
tipped b) you or a child standing, ,sittin,,_ or
leailiilob Oil
_lI1 ol)eI1
door.
• After installing the Anti-Tip dexice, xerili that it
is in place b) careflflly attempting to tilt the
I'll iloe forward.
• This ran,,e has been designed to meet all
recognized industry tip standards for all normal
conditions.
• The use of this dexice does not preclude tii,)Dim,
of the range when not properly installed.
• If the Anti-Tip dexice supplied with the range
does not lit this application, use the tmixersal
Anti-Tip dexice X_B2X7909.
A. Mark the wall where the RIGHT EDGE of the range
is to be located. Be sm'e to allow fl)r the cotmtertop
overhang if you intend to install the range next to
cabinets.
Slotted head
Marked edge of range
2_ toward the
B. I.ocate the outside edge of the de_ice _ J "
center of the range from the marked edge of the
I'}l I1 re
C. Using the dexice as a template, mark the position of
the hole for the screw.
D. For wood constH/ction, drill a pilot hole at an angle
of 20 degrees from the horizontal. A nail
or awl may
be used if a drill is not a_ailable.
Mount the Anti-Tip dexice with the screw provided.
For ceuleil[ or COilcrete COIlStItlctioI1, VOII
will
need
a 1/4" x 1½" lag bolt and a 1/2" O.D. sleeve anchor;
which are not provided. Drill the recommended size
hole tot the hardware.
[] INSTALLING THE ANTI-TIP
DEVICE (CONT.)
Wallboard
Back of range
screw
Install the sleeve anchor into the drilled hole and then
install the lag bolt through tile device. The bolts must
be
properly
tightened as recommended fin" the
hardware.
E. Slide tile range against the wall, and check
fin"
proper installation by grasping the ti'ont edge ot the
cooktop and careflflly attempting to tilt the range
fin'ward.
WHEN ALL HOOKUPS ARE
COMPLETED
Make sure all controls are left in the off position. Make
sure the flow of combustion and ventilation air to the
range is unobstructed.
CONVERTING TO LP GAS (or
converting back to natural gas from LP)
This range leaves the factory set for use with natural
gas. If you want to convert to LP gas, the conversion
must be performed by a qualified LP gas installer,
The conxet_ion instructions and I,P orifices can be
fotmd attached to the ran(,e_ next to the l)ressure
regtflator.
Kee I) these instHlctions and the orifices in case you
_V_lIlt to coil_.ert back to Ilattlral gas.
49