Usingthe clock and timer,
ge.com
Make sure the clock is set to the
correct time of da,f
To Set the Clock
The
clock
must
be set to tile correct
time
of day fin" tile automatic
oven
tinting
tractions
to work
properly:
Tile
time
ot
day cannot
be changed
dm'ing
a timed
baking
or self:cleaning
cycle.
[]
Press tile CLOCKpad.
[]
Press tile HOUR and MIN + or
- pads to set tile time of day,
[]
Press tile START pad.
The timer is a minute timer onl_
The timer does not control
oven
operations.
The maximum se_ting on
the timer is 9 hours and 59 m&utes.
To Set the timer
[]
[]
Press tile KITCHEN TIMER
ON/OFF pad.
Press tile HOUR and MIN + or
- pads tmtil tile amo/mt of time
you want sho_vs in tile display.
Tile nlaximum
time you can enter
in minutes
is 59. Cooking
times
more
than 59 minutes
should
be
changed
to hom_ and minums.
For example,
enter 90 minutes
as
1 horn; 30 mimltes.
If you make a mistake, press
KITCHENTIMERON/OFF and
begin
again.
[]
Press
tile
STARTpad.
After pressing the STARTpad, SETdisappears,
this tells you the time b counting down,although
the display doesnot changeuntil one minute
has passe_ Seconds will not be shown in the
display until the/astminute is countingdown.
[]
"_ hen tile timer reaches
:00, tile
control
will beep 3 times followed
by one beep eveI T 6 seconds
until
tile KITCHEN TIMERON/OFF
pad
is pressed.
The&second tone can be canceledby following
the steps in the Special features of your oven
control section under Tones at the Endof a
TimedCycle.
ToReset the Timer
If tile display is still showing
tile time
remaining,
you may change
it by pressing
tile KITCHEN TIMER ON/OFF pad, then
press tile HOUR ",rod MIN + or-
pads
tmtil tile time you want appea_
in tile
display:
If tile remaining
time is not in tile display
(clock, delay start or cooking
time are in
the display),
recall the remaining
time b)'
pressing
tile KITCHEN TIMER ON/OFFpad
and then pressing tile HOUR and MIN+
OI" -- pads
to
entei"
tile
new
tillle
veil
want.
ToCancel the Timer
Press KITCHEN TIMER ON/OFF pad twice.
Control Lockout
Yourcontrol wi// a/low you to lock out the touch
pads so they cannot be activated when pressed.
NOTE: On models with touch pad controls
for both ovens, this activates this feature for
both ovens.
To lock/unlod<
tile controls:
[]
Press tile HOUR and MIN-pads
at
tile same thne fi)r 3 seconds
until
tile display shows LOC ON.
[]
To unlock tile control,
press tile
HOUR and MIN-pads
at the same
time fin" 3 seconds
until tile display
shows LOCOFF.
When
this tbature
is on and tile touch
pads are pressed,
tile control
will beep
and tile display will show LOC ON.
::J_:: Thecontrol/ockoutmode affects aft touch
pads. No touch pads will work when this
feature is activated
iJi::Onmodels with ovenknob{s),this feature is
not available for the lower oven.
!i> This adjustment will be retained in memory
after a power failure.
13
Need help?
Do you have a question about the JKP20 and is the answer not in the manual?