Table of Contents
Advertisement
BP7333 CF750 MAYA ZEN
IMPORTANT:
Your
supplied with a Fan/Light Wall Control
(transmitter) and a remote control
SW105 Receiver which mounts under
the ceiling cover. This system allows
you to regulate your ceiling fan speed,
airflow direction, and light intensity. An
optional
Emerson
Remote Control may also be used.
IMPORTANT: Your ceiling fan will not
function
properly
damaged, if used with any wall dimmer
switch or control other than the
Emerson controls listed above.
Electrical Requirements
Your new ceiling fan will require a
grounded electrical supply line of 120 volts
AC, 60 Hz, 15 amp circuit.
The outlet box must be securely anchored
and capable of withstanding a load of at
least 50 pounds.
WARNING
!
To reduce the risk of fire, electric shock,
or personal injury, mount fan to outlet box
marked "Acceptable for Fan Support",
and use screws supplied with outlet box.
Most outlet boxes commonly used for
support
of
light
fixtures
acceptable for fan support and may need
to be replaced. Consult a qualified
electrician if in doubt.
If your fan is to replace an existing ceiling
light fixture, turn electricity off at the main
fuse or circuit breaker box at this time and
remove the existing light fixture.
WARNING
!
Turning off wall switch is not sufficient.
To avoid possible electrical shock, be
sure electricity is turned off at the main
fuse or circuit breaker box before wiring.
All wiring must be in accordance with
National and Local codes and the ceiling
fan must be properly grounded as a
precaution against possible electrical
shock.
12/22/06
7:59 AM
Page 5
ceiling
fan
is
To avoid possible fire or shock, follow all
wiring
electrical work not described in these
instructions should be done or approved
by a licensed electrician.
Electric
SR110
Preliminary Procedures
IMPORTANT: Before assembling your
and
may
be
ceiling fan, refer to sections "Setting
Operating Frequency of Wall Control
and Receiver" and "Battery Installation
of Wall Control", page 11. These
sections instruct you how to:
a. Set the operating frequency of the
fan/light wall control and the remote
control receiver.
b. Install the fan/light wall control in
the wall box.
You will then be ready to proceed with
the assembly and installation of your
ceiling fan.
How to Assemble Your
are
not
Turning off wall switch is not sufficient.
To avoid possible electrical shock, be
sure electricity is turned off at the main
fuse or circuit breaker box before wiring.
All wiring must be in accordance with
National and Local codes and the ceiling
fan must be properly grounded as a
precaution against possible electrical
shock.
1. Mount the fan blades to the blade
flanges using three M5 x 6mm washer
head screws (supplied) (Figure 1).
Figure 1
5
WARNING
!
instructions
carefully.
Any
Ceiling Fan
WARNING
!
M5 x 6mm
WASHER HEAD
SCREWS (3)
FAN BLADE
BLADE
FLANGE
Advertisement
Table of Contents
