Settings
device to connect to the destination using this access point
automatically.
Select
Options
Advanced settings
>
following:
Network type
— Select the internet protocol type to
•
transfer data to and from your device. The other settings
depend on the selected network type.
Phone IP address
(for IPv4 only) — Enter the IP address
•
of your device.
DNS addresses
— Enter the IP addresses of the primary
•
and secondary DNS servers, if required by your service
provider. To obtain these addresses, contact your internet
service provider.
Proxy server address
•
server.
Proxy port number
— Enter the port number of the proxy
•
server.
WLAN internet access points
Select
Menu
Control panel
>
Connection
Destinations
>
the instructions on the display. Or, open one of the access
point groups, select an access point marked with
select Edit.
Use the instructions provided by your service provider to edit
the following:
WLAN network name
•
Search for
networks. If you select an existing network,
154
and from the
— Enter the address of the proxy
Settings
and
>
Access
point, and follow
>
— Select
Enter manually
WLAN network mode
determined by the settings of its access point device.
Network status
•
displayed.
WLAN network mode
•
hoc network, and to allow devices to send and receive data
directly; a WLAN access point device is not needed. In an
ad hoc network, all devices must use the same WLAN
network name.
WLAN security mode
•
WEP,
802.1x
you select
802.1x, and WPA functions can be used only if the network
supports them.
Use access point
•
device to ask for confirmation before the connection using
this access point is created or
device to connect to the destination using this access point
automatically.
To enter the settings for the selected security mode, select
WLAN security
Advanced WLAN settings
, and
Select
Options
following:
IPv4 settings
•
subnet IP address, the default gateway, and the IP
addresses of the primary and secondary DNS servers.
or
Contact your internet service provider for these addresses.
IPv6 settings
•
and
WLAN security mode
— Define whether the network name is
— Select
Ad-hoc
— Select the encryption used:
(not for ad hoc networks), or WPA/WPA2. If
Open
network, no encryption is used. The WEP,
— Select
After confirmation
Automatically
settings.
Advanced settings
>
— Enter the IP address of your device, the
— Define the type of DNS address.
© 2008 Nokia. All rights reserved.
are
to create an ad
to set the
to set the
and from the