Download  Print this page

Something Not Working - Electrolux EDC 77150W User Manual

Hide thumbs


Table of Contents
20 electrolux something not working

Something not working

Certain problems are due to lack of simple maintenance or oversights, which can be
solved easily without calling out an engineer. Before contacting your local Service
Centre, please carry out the checks listed below.
During machine operation it is possible that the red Start/Pause pilot light flashes to
indicate that the machine is not working.
Once the problem has been eliminated, press the Start/Pause button to restart the
programme. If after all checks, the problem persists, contact your local Service
Dryer does not work.
Drying results
Loading door does not
Possible cause
Mains plug is not plugged in
or fuse is not working
Loading door is open.
Have you pressed the
START/ PAUSE button?
Wrong programme selected.
Lint filter clogged.
Heat exchanger clogged with lint.
Incorrect volume of laundry.
Ventilation slots in base area
covered up.
Residue on inside surface of
drum or drum ribs.
Conductance of water at
installation site differs from
standard setting of machine.
Fine strainer not in place
and/or large mesh filter not
locked in place.
Plug in at mains socket.
Check fuse in fuse box
(domestic installation).
Close loading door.
button again.
Select a different programme the
next time you dry (see "Overview
of programmes" section).
Clean lint filter.
Clean heat exchanger.
Observe recommended
loading volumes.
Uncover ventilation slots in
base area.
Clean inside surface of drum
and drum ribs
Re-programme standard setting
for degree of drying (see
'Programming options' section).
Install fine strainer and/or
snap large mesh filter into


Table of Contents

  Also See for Electrolux EDC 77150W