Leds; Table 2-1. Led Descriptions - NETGEAR FE508 - Hub Installation Manual

LEDs

The LEDs on the front panel of the switch and two vista LEDs on each RJ-45 connector allow you
to identify the following information:
• Status of the switch power supply
• For each 10/100 Ethernet port:
— Link status
— Data transmission or receive activity
— Collision occurrence
— Full-duplex or half-duplex mode
— 10 Mbps or 100 Mbps speed transmission
Table 2-1 describes each LED on the front panel of the switch.
Table 2-1. LED descriptions
Label Color
Power Green
Rx/Tx/Collision Green
Yellow
100 Mbps Green
Link Green
FDX Green
Physical Description
Installation Guide for the Model FS508 Fast Ethernet Switch
Activity Description
On Power is supplied to the switch.
Off Power is disconnected.
Blinking Packet transmission or reception is occurring on the port.
The blinking action corresponds to the number of packets
that are transmitted or received.
Blinking Data collisions are occurring on the port. The blinking
action corresponds to the number of collisions. When a
collision occurs, the connected device pauses and
transmits again after waiting a specified time.
Note that occasional collisions are normal.
On The port is operating at 100 Mbps.
Off The port is operating at 10 Mbps.
On A valid link is established on the port.
Off A link is not established on the port.
On The port is operating in full-duplex mode.
Off The port is operating in half-duplex mode.
2-3