Normal/Uplink Push Button; Figure 2-3. Link/Rx And Part (Partition) Leds On The Rj-45 Ports - NETGEAR FE104 - Hub Installation Manual

Installation Guide for the Model FE104 and Model FE108 Fast Ethernet Hubs
As illustrated in Figure 2-3, two LEDs are positioned at the top corners of each RJ-45 connector.
The left indicator is the Link/Rx (receive) LED, and the right indicator is the Part (partition) LED.
Both LEDs are described in Table 2-1.
Link/Rx Part
184EA
Figure 2-3. Link/Rx and Part (partition) LEDs on the RJ-45 ports

Normal/Uplink Push Button

The Normal/Uplink push button on the front panel of the hub, as illustrated in Figure 2-4, allows
you to select uplink (MDI) or normal (MDI-X) wiring for Port 4 on the Model FE104 hub and Port
8 on the Model FE108 hub. Ports 4 and 8 are configured for normal wiring when the push button is
in the out position. When the push button is pressed in, Ports 4 and 8 are configured for uplink
wiring.
Link/Rx Part
1 2 3 4
Model FE104
Figure 2-4. Normal/Uplink push button
2-4
MODEL FE104
Link/Rx Partition
Normal/Uplink
1 2
Link/Rx Part
3
4 5 6 7
Model FE108
Normal/Uplink
8
183EA
Physical Description