Digital Audio (Digital Audio Input); Sp Config (Speaker Configuration) - Onkyo HT-S5600 Owner's Manual

3. Digital Audio (Digital Audio Input)

1 2 3 4
Menu Digital Audio
If you connect a component to a digital audio input, you
must assign that input to an input selector. For example, if
you connect your CD player to the COAXIAL IN 1, you
must assign "COAXIAL1" to the "TV/CD" input selector.
Here are the default assignments.
Input selector Default assignment
BD/DVD COAXIAL1
VCR/DVR - - - - -
CBL/SAT COAXIAL2
GAME - - - - -
AUX - - - - -
TV/CD OPTICAL
■
BD/DVD, VCR/DVR, CBL/SAT, GAME, AUX,
TV/CD
COAXIAL1, COAXIAL2, OPTICAL:
Select the input to which the component has been
connected.
- - - - -:
Select if the component is connected to an analog
audio input.
Note
• When an HDMI IN is assigned to an input selector in
(➔ page 38), the same HDMI IN will be set as
"HDMI Input"
a priority in this assignment. In this case, if you want to use the
coaxial or optical audio input, make the appropriate selection in
the "Audio Selector" (➔ page 44).
• Supported sampling rates for PCM signals (stereo/mono) from a
digital input (optical and coaxial) are 32/44.1/48/88.2/96 kHz/16,
20, 24 bit.

4. Sp Config (Speaker Configuration)

5 6 1 2
Menu
Some of the settings in this section are set automatically
by Audyssey 2EQ
(➔ page 26).
Here you can check the settings made by Audyssey 2EQ
Room Correction and Speaker Setup, or set them manually,
which is useful if you change one of the connected
speakers after using Audyssey 2EQ Room Correction and
Speaker Setup.
This section explains how to specify which speakers are
connected and their sizes.
For speakers with a cone diameter larger than 6-1/2 inches
(16 cm), specify Large (full band). For those with a
smaller diameter, specify Small (default crossover
100 Hz).
The crossover frequency can be changed in the "Crossover
(Crossover Frequency)"
Note
• These settings are not available in either of the following cases:
– A pair of headphones is connected.
– The "Audio TV Out" setting is set to "On"
– "HDMI CEC (RIHD)" is set to "On"
you're listening through your TV speakers.
3 4 5 6
Sp Config
® Room Correction and Speaker Setup
Cone diameter
(➔ page 40).
(➔ page 46).
(➔ page 46) and
En-39
Advanced Operations
■
Powered Zone 2
No
Yes:
Zone 2 speakers can be used. (Powered Zone 2
enabled).
Note
• When the "Powered Zone 2" setting is set to "Yes" and Zone 2
is turned on, the surround back and front high speakers cannot be
used.
■
Subwoofer
Yes
No
■
Front
Small
Large:
Select based on the cone diameter.
Note
• If the "Subwoofer" setting is set to "No", this setting is fixed to
"Large".
■
Center , Surround
*1 *1
Small
Large:
Select based on the cone diameter.
None
■
Front High *2*3*4
Small
Large:
Select based on the cone diameter.
None
■
Surround Back
*2*3*5
Small
Large:
Select based on the cone diameter.
None