Ph2200W/4 - EarthQuake PowerHouse PH800W/2 Owner's Manual

PH2200W/4

Remote ON Auto ON
Signal Sensor: Four RCA level inputs
Remote ON/Auto crossed outputs, can be
ON feature (see used to feed other
page 5). amplifiers in the system
Speaker
To battery (+)
Outputs
To remote turn on / trigger
Minimum
4 Ohm
To car chassis / ground
Mono
10
Specifications Are Subject To Change Without Notice
3-way switch feeds, RCA outputs
3/4 a full range, high-pass or low-
pass signal.
3-way switch for each block
runs CH1/2 or CH3/4 in low
-pass, full-range or high-
pass mode.
Tonal controls CH3/4:
+ 12dB boost @ 12kHz
+ 18dB boost @ 45Hz
Four RCA level inputs
with a range of 0.2V to
5V. RMS.
The gain knob is not a volume control.
It is designed to match the input level
of the amp to the output level of the
source unit. Over driving -clipping- the
input stage of the amp will cause
damage to the amplifier (Please refer
to table for settings).
GND REM BAT
POWER
Two 30A Fuses
Set Xover knob to
Minimum (20Hz), &
set Xover switch to
by-pass, (full-range)
FC6.2 Midrange FC6.2 Midrange
FC6.2 FC6.2
Tweeter Tweeter
FC6.2 Midrange FC6.2 Midrange
FC6.2 FC6.2
Tweeter Tweeter
www.earthquakesound.com
11