Kodak 8004707 - MAX Water & Sport Setup Manual

CIS-236
August 2002
CURRENT INFORMATION SUMMARY
Wind Off
Check the frame-counter window to make
sure the "0" is aligned with the arrow.
If not, grip the camera and cover the lens,
press the shutter button , and turn the
thumbwheel until the film is fully rewound.
The film is fully rewound when the thumb-
wheel rotates freely and does not stop or lock.

Break Off Film Door

Using the special tool, hold the camera firmly
and pull upwards to break off the film door
and remove the film.
• Place the used camera in the
5
Kodak recycle bin.
• Visit our Web site at http://
www.kodak.com/go/kes for details
about Kodak's recycling program.
• Call Kodak's advertising distribution
center at (800) 847-8755 to order
a Kodak hand-opening tool.
Opening Instructions for the
KODAK FUN SAVER One-Time-Use Camera
Wear eye protection when opening all cameras.
shutter button
0
thumbwheel

Insert Tool

Insert the special tool into the end slot.

Remove Film

Opened camera
with film removed.
CAUTION: Before you attempt the
opening tasks, make sure the tool is
fully engaged with the camera body to
prevent tool slippage.
CAUTION: This camera body contains
a high-voltage capacitor and circuit
board. To avoid electric shock, do not
pry apart the front and back sections
of the camera. Remove only the film
from its respective compartment. If
sections of the camera are separated,
do not touch the circuit board.
Exposed
Film