INSTALLING LOGS AND GLOWING
EMBERS
A.4.piece.ceramic.log.set.comes.packed.in-
side the unit firebox. Removal of glass door is
necessary.to.unpack.and.assemble.logs.and.
add. hearth. treatments.. Follow. steps. under.
Removing/Replacing Glass Door, page 18 to
access.logs.and.burner.
Assemble. logs. and. add. burner. treatments.
as.follows:
1.. Position.base.log.onto.burner.log.mounts.
(see.Figure.31).
Top.Left.
Log
Rear.
Log
Burner.
Base.Log
Log.
Mounts
Figure 31 - Installing Logs
117437-01D
FIREPLACE INSTALLATION
Continued
Top.
Right.
Log
Rear.Log.
Stand
Burner.
Pan
www.desatech.com
.
Note: Cut out on bottom should fit over
mounts and base log should be positioned
against rear panel.
.. Position.holes.on.bottom.of.rear.log.over.
pins.on.base.log.(see.Figure.31).
3.. Position. top. left. log. and. top. right. log.
onto.rear.log.and.base.log.as.shown.in.
Figure.31.
4. Break ember material into quarter sized
pieces.and.place.a.single.layer.along.the.
full. length. of. ember. tray. to. hide. bottom.
edge.of.base.log.(see.Figure.3).
5.. Replace. glass. door. and. louver. panels.
(see. Removing/Replacing Glass Door,
page.18).
WARNING: The glass door
must be securely in place before
running this fireplace. Do not run
this fireplace if glass is missing
or broken.
Ember.
Tray
Ember.
Material
Figure 32 - Applying Ember Material
19