Desa CB36N Installation And Owner's Operation Manual page 18

Removing Louver Panels
Remove. top. and. bottom. louver. panels. by.
simultaneously. pulling. both. top. end. spring.
latches.toward.center.of.appliance.until.they.
are. disengaged. from. locating. holes. (see.
Figure.8)..Repeat.for.bottom.spring.latches.
and.pull.louvers.outward..To.install.or.replace.
items removed, simply reverse procedures
above.
Louver.
Panel
Figure 28 - Removing Louver Panel
Removing/Replacing Glass Door
WARNING: Handle glass
door panel with care. Do not
strike, slam or otherwise abuse
glass. Do not operate fire-
place with glass door removed,
cracked or broken.
If replacement of glass is necessary, the
entire assembly, glass and frame, must be
replaced. If glass is broken, wear gloves and
tape.remaining.fragments.onto.frame.
1. Placing a screw driver or your finger tips
into. gap. between. lower. glass. panel. rail.
and bottom face frame, lift glass door as-
sembly.until.door.pins.clear.locating.holes.
in.bottom.face.frame.(see.Figure.9).
.. Swing.bottom.glass.panel.assembly.out.
until.door.pins.on.lower.rail.clear.bottom.
face.frame.(see.Figure.30).
3.. Lower.door.down.until.upper.door.pins.are.
free.of.locating.holes.in.spring.clips.and.
place.in.a.safe.area.
4.. Replace.glass.panel.in.reverse.order.by.
inserting top door pins into spring clips,
lifting.up.at.lower.frame.rail.and.locating.
bottom.pins.in.holes.on.lower.face.frame.
18
FIREPLACE INSTALLATION
Continued
Spring.
Latch
www.desatech.com
1. Lift Up Panel
at Lower Rail
Glass Panel
Frame Rail
Figure 29 - Removing/Replacing Glass
2. Swing Out
Panel
3. Lower
Panel Out
Glass Panel
Frame Rail
Figure 30 - Removing/Replacing Glass
Spring Clips
Door
Locating
Hole
Door Pin
Door
117437-01D