Desa CB36N Installation And Owner's Operation Manual page 22

. IMPORTANT:.Be.sure.to.press.the.ON/
OFF.buttons.on.hand-held.remote.control.
unit.for.up.to.3.seconds.to.assure.proper.
operation.
.. Press.ON/OFF.button.to.turn.the.burner.
on.and.off.
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: All remote control accessories must
be purchased separately (see Accessories,
page 31). Follow instructions included with
the remote control.
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions, page 21.
After lighting, let pilot flame burn for about
one.minute..Turn.control.knob.to.ON.position..
Adjust flame adjustment knob anywhere be-
tween.HI.and.LO..Slide.the.selector.switch.to.
the.REMOTE.position.(see.Figure.36).
Note: Burner may light if hand-held remote
was on when selector switch was last turned
off. You can now turn burner on and off with
hand-held remote control unit.
IMPORTANT:.Do.not.leave.selector.switch.in.
the.REMOTE.or.ON.position.when.pilot.is.not.
lit..This.will.drain.battery.
Blower.Control.Knob.
(Optional.Accessory)
OFF
Selector.Switch.in.
Remote.Position
Figure 36 - Setting the Selector Switch,
Gas Control Knob and Variable Control
Knob for Remote Operation
ON/OFF SERIES MODEL HRC100
Hold.control.button.on.hand-held.remote.until.
burner.turns.on..Hold.control.button.again.until.
burner.turns.off.(see.Figure.37).

OPERATING FIREPLACE
Variable.
Control.Knob
ON
Gas.Control.Knob.
in.ON.Position
www.desatech.com
Continued
.
TO.LOCK
remote control until light stops flashing. Hand-
held remote control is now locked. If fire is on
it. will. be. turned. off. automatically.. In. locked.
state, light will not light up when any button
is.pressed.
TO UNLOCk
on. hand-held. remote. control. until. light.
stops. flashing.. Hand-held. remote. is. now.
unlocked.
Indicator.
Light
Figure 37 - On/Off Hand-Held Remote
MOUNTED SWITCH
WARNING: Do not connect
the appliance gas controls to a
120 VAC power source. Damage
or injury may occur.
Light. fireplace. as. instructed. in. Lighting
Instructions. on. page. 1. .. If. using. an. HRC.
remote with a wall switch, set remote selec-
tor.switch.to.the.ON.position.(see.Figure.36)..
Wall.switch.may.now.be.used.to.turn.burner.
flame ON and OFF.
To turn fireplace off, turn wall switch and/or
remote. selector. switch. to. the. OFF. position.
and.turn.gas.control.knob.back.to.PILOT..Pilot.
will.remain.lit.
IMPORTANT: To turn pilot off, turn gas control
knob.on.heater.to.the.OFF.position.
press.both.buttons.on.hand-held.
.
press. both. buttons. together.
Control Unit HRC100
OPTIONAL GWMS2
ON/OFF WALL
Control.
Button
117437-01D