Electronic Ignition - Desa CB36N Installation And Owner's Operation Manual

INSTALLING OPTIONAL CONTROLS
4.. Connect.one.wire.from.receiver.to.male.
connector.on.high.limit.harness.and.one.
to "TH" on control valve (see Figure 14,
page.1).
5.. Locate.two.plastic.mounting.clips.provided.
with.kit.
6. Use clips to mount receiver on remote
mounting.bracket.as.shown.in.Figure.16.
Plastic.Mounting.
Clips
Towards Front
Remote.Receiver
Figure 16 - Mounting Remote Receiver to
Bracket
Installing 9-Volt Alkaline Battery in Hand-
Held Remote Control Unit
1.. Remove.battery.cover.on.back.of.remote.
control.unit.
.. Attach.terminal.wires.to.a.9-volt.alkaline.
battery.(not.included)..Place.battery.into.
battery.housing.(see.Figure.17).
3.. Replace.battery.cover.onto.remote.con-
trol.unit.
Battery.
Cover
Terminal.
Wires
9-Volt.
Battery
Figure 17 - Installing Battery in Hand-
Held Control Unit (HRC100 Series)
117437-01D
Continued
REMOTE ON OFF
Remote.
Control.
Battery.
Unit
Housing
www.desatech.com
INSTALLING OPTIONAL WIRELESS
REMOTE CONTROL - MODEL WRC

(Electronic Ignition)

Installing and Activating the Remote
Receiver
1.. Open.bottom.louver.and.locate.plug.re-
ceptacle..Plug.receptacle.is.located.either.
on.right.or.left.side.of.cabinet.
.. The.WRC.model.receiver.does.not.require.
a. battery.. Receiver. can. be. installed. by.
first plugging short extension cord into
fireplace receptacle. Then plug receiver
unit.into.extension.cord..Finally.plug.igni-
tion. module. plug. into. receiver. unit. (see.
Figure.18).
3.. Activate. remote. handset. battery. by. re-
moving.insulating.tab.on.back.of.handset.
(see.Figure.19)..Battery.is.included.pre-
installed.
4.. Once.battery.is.activated.unit.is.ready.to.
use.
5.. Replace.bottom.louver.panel.
Fireplace.
Receptacle
Extension.Cord
Figure 18 - Installing WRC Remote Receiver
Battery.Cover
1.Volt.Battery
Figure 19 - Installing Battery into Back of
Handset
Remote.
Control.
Receiver
Ignition.
Module.
Plug
Back.of.Handset
Pull.to.
Remove.
Insulation.
Tab
13