Smart Technologies Rear Projection SMART Board 2000i Projector Replacement Manual page 7

6. Set the projector down on a flat surface and remove the projector plate from the projector:
Using the provided hex key, loosen and remove the four sets of screws, spacers and
washers at the corners of the plate.
Cap Screw
Lock Washer
Flat Washer
Aluminum Spacer
7. Transfer the plate to the new projector and attach it using the same screws, spacers and
washers that were removed in the previous step.
99-00496-00 REV A0
Projector Replacement Guide for the 2000i
3