Smart Technologies Rear Projection SMART Board 2000i Projector Replacement Manual page 14

To move the image up or down
1. Crouch down in front of the screen.
Move Image Up or Down
2. Look underneath the pen tray and locate the Electronics Tray. Locate a plastic cap on the
right side of the Electronics Tray.
3. Remove the plastic cap to reveal an access hole.
4. Use the supplied 7/16" nut driver to loosen and tighten the bolt inside the access hole. This
action adjusts the vertical position of the image on the screen. Adjust accordingly.
10
Electronics Tray
Projector Replacement Guide for the 2000i
99-00496-00 REV A0