Download Print this page

Smart Technologies Rear Projection SMART Board 2000i Projector Replacement Manual page 11

For projector replacement kits nec mt1060r (03-00043) and nec mt860r (03-00041)

To adjust the image laterally

1. Crouch behind the projector and look at the projected image through the view port.

Image Side-to-Side Adjustment

2. Using the supplied 7/16" nut driver, loosen the two nuts on the left side of the projector plate.

3. Slide the projector plate to the right or left to adjust the image, and then tighten the two nuts.

Projector Replacement Guide for the 2000i

99-00496-00 REV A0

Table of Contents

Need help?

Do you have a question about the Rear Projection SMART Board 2000i and is the answer not in the manual?