Performance Data Sheet; Softener Specifications - Culligan Gold Series Owner's Manual

16

Performance Data Sheet

Culligan knows the more informed you are about your water treatment systems, the more confident
you will be about its performance. It's because of this and more than sixty years of commitment to
customer satisfaction that Culligan is providing this Performance Data Sheet to its customers.
IMPORTANT NOTICE: Read this Performance Data Sheet and compare the capabilities of this unit
with your actual water treatment needs. It is recommended that before purchasing a water treatment
unit, you have your water supply tested to determine your actual water treatment needs.
MANUFACTURER:
Culligan International Company,
One Culligan Parkway, Northbrook, IL 60062-6209 USA
(847) 205-6000
PRODUCT: Culligan Gold Series
TESTING CONDITIONS & RESULTS:
Flow Rate: 9.0 gpm
Pressure: : : : : 30 - 40 psi
Acidity: Non-Corrosive
Temperature: : : : : 68° (20°C)

SOFTENER SPECIFICATIONS:

Maximum Flow Rate: 9.0 gpm (34 Lpm)
Pressure Drop at Maximum Flow Rate: 15 psi (102 kPa)
Operating Temperature Range: 33 - 120°F (1 - 50°C)
Maximum Drain Flow Rate: 2.0 gpm (8 Lpm)
Working Pressure Range: 20 - 120 psi (140 - 860 kPa)
The Culligan Gold Series water softeners are tested and validated by WQA against ANSI/NSF
Standard 44 for the effective reduction of calcium and magnesium (hardness).
Refer to the Specifications, Familiarization and Warranty section of this Owner's Guide for more
specific product information. To avoid contamination from improper handling and installation, your
system should only be installed and serviced by your Culligan Man. Performance will vary based on
local water conditions. The substances reduced by this system are not necessarily in your water.
Culligan water softeners are designed to work with any salt of good quality, although it is recom-
mended that you ask your local Culligan Man for his suggestion on the best type and grade of salt to
use in this softener.
NOTICE: This softener is not intended to be used for treating water that is microbiologically unsafe or
of unknown quality without adequate disinfection before or after the system.
9" Water Softener
™
Capacity: 18,200 grains @ 4.0 lb. salt
27,300 grains @ 8.0 lb. salt
30,900 grains @ 12.0 lb. salt
pH: 7.6