Cradlepoint IBR60 User Manual page 72

Integrated broadband router
Table of Contents

Advertisement

IBR600| USER MANUAL Firmware ver. 3.3.0
CRADLEPOINT
Ethernet Port Group Editor
A Port Group represents a logical grouping of Ethernet
ports. Any computers physically connected to ports in a
group will be allowed to freely communicate with each
other.
Since the IBR600 has only 2 Ethernet ports, this feature
will rarely be necessary. It is possible, however, to set both
ports as LAN ports (or both ports as WAN ports) and then
either separate them or group them together. (For
example, you could use one for the primary network and
one for a guest network, or you could use both for the
primary network.)
NOTE: When a port group uses the LAN mode you must separately
ensure that this logical interface is attached to a Local IP Network in
the top panel of this page.
Port Group ID: The Group ID field provides a reference to
this grouping of ports to be used in other parts of the router
configuration. For example, this ID is referenced in the
Local IP Networks configuration to attach this logical group of Ethernet ports with a network configuration. Use a simple
short text phrase to describe a group, such as "main", "guestports", "backup_wan", etc.
Select one or more ports to create a port group that you can subsequently attach to a network in the Local Network
Editor. Double-click on any of the Ethernet ports shown on the left in the Available section to move them to the Selected
section on the right (or highlight a port and click the + button). To deselect an Ethernet port, double-click on an interface in
the Selected section (or highlight the port and click the – button).
© 2011 CRADLEPOINT, INC.
PLEASE VISIT
HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/
FOR MORE HELP AND RESOURCES
PAGE 70

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ibr600

Table of Contents