Table of Contents
Advertisement
than 15 seconds, the current value of Brightness, Contrast and Colour
Select are automatically stored.
current value is stored.
not stored if you power off before 15 seconds passed.
l
Store the adjusted data by pressing the button [STORE I.
@One adjusted value for each video mode can be stored for the functions
below.
Horizontal Position
Pincushion, Trapezoid,
used. Refer to "AUTOMATIC SETTINGS"
overwritten.
q
The geometry for each standard video mode has been preset. (refer to 'STANDARD
SETTINGS") The user settings are available for up to 13 video modes.
q
The video mode is detected by the horizontal / vertical frequency and polarity of the
horizontal / vertical sync. signal. If two video modes are similar, much, there is a
possibility that they will not be identified as different.
(at the power QlJ only)
I
I
Rotation, Colouk (Red, Green and Blue)
Colour balance is stored in the [ :.U 1.
Contrast, Brightness, Colour Select
These are usually stored automatically. Refer
to "AUTOMATIC STORE".
Cl When a new value is stored, the previous data is
overwritten.
Horizontal Size, Vertical Position, Vertical Size,
button
+ 1 and
ADJUST
to reset to the original standard settings.
Use this function only when you want to cancel all your
. All your storing data will be lost and the all adjustment
. .
If you perform this function the reset will take approximately
10 seconds.
ADJUST
Advertisement
Table of Contents
