Power On/Off; Turning On The Power; Turning Off The Power - Hitachi CP-SX1350 Operating Manual

Power ON/OFF

Power ON/OFF
WARNING • When the power is ON, a strong light is emitted. Do not look
into the lens or vents of the projector.
NOTE
• Turn the power on/off in right order. Please power on the projector before
the connected devices. Power off the projector after the connected devices.

Turning On The Power

1 Remove the lens cap.
Set the power switch to [ | ] (ON).
2
The STANDBY/ON indicator will light to solid orange.
Press the STANDBY/ON button.
3
The projector lamp will light up and the
STANDBY/ON indicator will begin blinking green.
When the power is completely on, the indicator
will stop blinking and light green.
Use the LENS SHIFT buttons to shift the
4
picture upward or downward.
Select an input signal according to the
5
section "Selecting An Input Signal" of the
following page.

Turning Off The Power

Press the STANDBY/ON button.
1
The message "Power off?" will appear on
the screen for approximately 5 seconds.
Press the STANDBY/ON button again while
2
"Power off?" the message is visible.
The projector lamp will go off, and the
STANDBY/ON indicator will begin blanking orange.
Then the STANDBY/ON indicator will stop blinking
and light to solid orange when the lamp cooling is
complete.
Switch the power switch to [O] (OFF).
3
The STANDBY/ON indicator will go off.
Attached the lens cap.
4
STANDBY/ON
STANDBY/ON button / indicator
Power switch (ON position)
LENS SHIFT
buttons
STANDBY/ON
STANDBY/ON button / indicator
Power switch (OFF position)
LASER INDICATOR
STANDBY/ON VIDEO RGB
+ + +
LENS SHIFT FOCUS ZOOM
– – –
S C S
STANDBY/ON
STANDBY/ON
button
LASER INDICATOR
STANDBY/ON VIDEO RGB
+ + +
LENS SHIFT FOCUS ZOOM
– – –
BLANK ASPECT LASER
LASER INDICATOR
STANDBY/ON VIDEO RGB
+ + +
LENS SHIFT FOCUS ZOOM
– – –
S C S
STANDBY/ON
STANDBY/ON
button
15