Hitachi CP-SX1350 Technical User's Manual

Hitachi projector user manual
Hide thumbs Also See for CP-SX1350:

Advertisement

Quick Links

Projector
CP-SX1350
CP-SX1350
User's Manual - Operating Guide
User's Manual - Operating Guide
TECHNICAL
Dimensions
Dimensions
[unit: mm]
210
420
73
85.5 (at the bottom of lens position) to 92.99 (at the top of lens position)
1

Advertisement

Table of Contents
loading

Summary of Contents for Hitachi CP-SX1350

  • Page 1 Projector CP-SX1350 CP-SX1350 User's Manual - Operating Guide User's Manual - Operating Guide TECHNICAL Dimensions Dimensions [unit: mm] 85.5 (at the bottom of lens position) to 92.99 (at the top of lens position)
  • Page 2 Refer to the number of display pixels above. • Although the projector can display signals with resolution up to UXGA (1600 x 1200), the signal will be converted to the projector’s panel resolution before being displayed. The best display performance will be achieved if the resolutions of the input signal and projector panel are identical.
  • Page 3 Initial Set Signals Initial Set Signals The following signals are used for the initial settings. The signal timing of some computer models may be different. In such case, adjust the items V POSITION and H POSITION in the PICTURE-2 menu. Back porch b Display interval c DATA...
  • Page 4: Audio Out

    Connection T Connection T 5 4 3 2 1 e w q = - D-Sub 15 pin shrink jack Signal Video input Red Video input Green Video input Blue Ground M1-D iuytrewq=- 654321 M1-D jack Signal T.M.D.S. Data2 + T.M.D.S. Data2 - T.M.D.S.
  • Page 5: Remote Control

    Video output Green Video output Blue Ground REMOTE CONTROL • 3.5 dia. Stereo mini jack • To be connected with the remote control that came with the projector. DC OUT o The Ports (continued) o The Ports (continued) REMOTE CONTROL...
  • Page 6 Connection T Connection T CONTROL CONTROL port 1 2 3 4 5 5 4 3 2 1 6 7 8 9 9 8 7 6 D-Sub 9 pin D-Sub 9 pin plug jack About the details of RS-232C communication, please refer to the memo following page.
  • Page 7: Table Of Contents

    Connecting The Cable Turn off the projector and the computer power supplies. Connect the CONTROL port of the projector with a RS-232C port of the computer by a RS-232C cable. Use the cable that fulfills the specification shown in the previous page.
  • Page 8 • Provide an interval of at least 40ms between the response code and any other code. • The projector outputs test data when the power supply is switched ON, and when the lamp is lit. Ignore this data. • Commands are not accepted during warm-up.
  • Page 9: Header

    RS-232C Communication (continued) RS-232C Communication (continued) Command Data Chart Names Operation type Keystone V Increment Decrement Keystone V Reset Execute Keystone H Increment Decrement Keystone H Reset Execute Brightness Increment Decrement Brightness Reset Execute Contrast Increment Decrement Contrast Reset Execute 16:9 SMALL Aspect...
  • Page 10: Get

    RS-232C Communication (continued) RS-232C Communication (continued) Command Data Chart (continued) Names Operation type ENGLISH FRANÇAIS DEUTSCH ESPAÑOL ITALIANO NORSK NEDERLANDS PORTUGUÊS 日本語 Language SVENSKA SUOMI POLSKI TÜRKÇE NORMAL CINEMA Gamma DYNAMIC CUSTOM Custom Gamma Increment Decrement Custom MIDDLE Color Temp Custom User R Custom User G Header...
  • Page 11: Increment

    RS-232C Communication (continued) RS-232C Communication (continued) Command Data Chart (continued) Names Operation type Custom User B Color Balance R Increment Decrement Color Balance R Execute Reset Color Balance G Increment Decrement Color Balance G Execute Reset Color Balance B Increment Decrement Color Balance B Execute...
  • Page 12 RS-232C Communication (continued) RS-232C Communication (continued) Command Data Chart (continued) Names Operation type V Position Increment Decrement V Position Reset Execute H Position Increment Decrement H Position Reset Execute H Phase Increment Decrement H Size Increment Decrement H Size Reset Execute Over Scan Increment...
  • Page 13 RS-232C Communication (continued) RS-232C Communication (continued) Command Data Chart (continued) Names Operation type MIDDLE Video NR HIGH Auto Adjust Execute Auto off Increment Decrement TURN OFF Auto Search TURN ON My Screen Original Blue Blank Color White Black TURN OFF Blank on/off TURN ON My Screen...
  • Page 14 RS-232C Communication (continued) RS-232C Communication (continued) Command Data Chart (continued) Names Operation type Volume Increment Decrement TURN OFF Mute TURN ON Lamp Time Lamp Time Reset Execute Filter Time Filter Time Reset Execute Magnify Increment Decrement Freeze TURN OFF TURN ON Power Input Source Component...
  • Page 15 RS-232C Communication (continued) RS-232C Communication (continued) Command Data Chart (continued) Names Operation type PinP Size Upper Left Upper Right PinP Position Bottom Left Bottom Right PinP Audio Ch PinP Input S-Video Myscreen Lock IR Remote Front IR Remote Rear IR Remote Top Header BE EF 06 00...
  • Page 16 RS-232C Communication (continued) RS-232C Communication (continued) Command Data Chart (continued) Names Operation type Power Up Source Auto Adjust Enable Internal Speaker Lens Lock Remote ID Lens Header Last Ch BE EF 06 00 M1-D BE EF 06 00 BE EF 06 00 BE EF 06 00...

This manual is also suitable for:

Sx1350 - sxga+ lcd projectorCp-sx1350w

Table of Contents