Table of Contents
Advertisement
#define CMD_POWERUP
#define CMD_POWERDOWN
#define CMD_POWERAUTO
Defines the offset for the I/O port of the command port register.
1
Defines the reset command bit position.
2
Defines the window selector for commands that are used to set up the
3
device.
Defines the window selector for commands that control the operation of
4
the device.
Defines the window selector for specifying the hardware address of
5
the device.
Defines the window selector for the device's first-in/first-out (FIFO)
6
buffer.
Defines the window selector for commands that are used for diagnostic
7
purposes.
Defines a second window selector for commands that are used for
8
diagnostic purposes.
Defines the window selector for commands that are related to gathering
9
device statistics.
Defines the start 10Base2 Ethernet cable command.
10
Defines the receive (RX) disable command.
11
Defines the receive (RX) enable command.
12
Defines the receive (RX) reset command.
13
Defines the receive (RX) discard top packet command.
14
Defines the transmit (TX) enable command.
15
Defines the transmit (TX) disable command.
16
Defines the transmit (TX) reset command.
17
Defines the request interrupt command.
18
Defines the acknowledge interrupt command.
19
Defines the set interrupt mask command.
20
Defines the clear interrupt command.
21
Defines the receive (RX) filter command.
22
(0x1b<<11)
31
(0x1c<<11)
32
(0x1d<<11)
33
Defining Device Register Offsets 2–3
Advertisement
Table of Contents
