Hitachi HDR081 Instruction Manual page 29

The second press of the info button brings up a box containing a brief description of the currently
viewed programme.
You can now use the > button to change the programme description to that of the next programme on
the current channel.
PR+ / PR – (CHANNEL NAVIGATION )
There are two ways to navigate through the channels:
Pressing PR +/ PR - keys will take you to go to the next or the previous channel in the list.
Pressing a number key will activate a small digit entry window on the left upper corner of the
screen. After a digit is entered, the box will stay for 2 seconds while you enter another digit. If no
digit is entered during these 2 seconds, then the box will switch to the entered number channel.If a
number that is greater than the maximum number of channels is entered, the box will switch
automatically to the last channel.
Press OK button to display the channel list.
VOLUME CONTROL
The volume level of the sound from the receiver can
be altered with the VOL+ and VOL- keys on the
remote control handset. Pressing either key displays
a bar graph of the sound volume on the TV screen.The volume level selected will remain set, even
when the receiver is turned off and on again, until it is altered with VOL + and VOL - keys.The audio
volume adjustment for the receiver is independent of the volume control on your TV set. Be careful
that both volume controls are kept within reasonable levels so that when switching from analogue to
digital television viewing, or when first turning on your TV set, the sound level is not too high.
You can silence the sound from the receiver by pressing the MUTE key. The sound
remains muted until the MUTE key is pressed again, the VOL + or VOL- keys are
pressed. While the sound is muted in this way, the mute symbol is displayed in the top
left of the TV screen. The symbol is removed after 3 seconds, but the sound will remain
muted until the MUTE key is pressed for the second time and the mute symbol will display for 3
seconds.
PIP (PICTURE-IN-PICTURE)
Enables / disables PIP window.
PIP +: next channel in PIP
window.
PIP - : previous channel in PIP
window.
NOTE: PIP is only available when LOOP
THROUGH is connected. (Please see
page connection diagrams)
SWAP
Main window and PIP window
their places.
change
28