Power Cord (Mains Lead); Safety Precautions - Hitachi HDR082 Instruction Manual

Recorder
Table of Contents

Advertisement

POWER CORD (MAINS LEAD)

Do not place the product where a piece of furniture or other heavy object could trap the power cord
(mains lead). Handle the power cord by the plug. Do not pull out the plug by tugging the cord and
never touch the power cord when your hands are wet as this could cause a short circuit or electric
shock. Never make a knot in the cord or tie it with other cords. The power cords should be routed in
such a way that they are not likely to be stepped on. A damaged power cord can cause fire or give you
an electrical shock. Check the power cord periodically to see if it is damaged. If it is damaged, please
ask an approved service agent to replace it.
For your own safety read following instructions carefully before attempting to connect this device to the
mains.
This unit is designed to operate on a 220V-240V AC - 50Hz supply only. Connecting it to other power
sources may damage it. Ensure that the supply corresponds to the information on the rating label on
the bottom of the unit.
This digital terrestrial receiver is supplied with a moulded mains plug. This plug must not be cut off as
it may contain a special radio interference filter, the removal of which could lead to impaired per-
formance. If you wish to extend the lead, obtain an appropriate safety approved extension lead or
consult your dealer.
Observe the manufacturers instructions when connecting extension leads to the set. Check the fuse
rating on the new plug, this should be fitted with a 5 Amp fuse which conforms to either ASTA or BSI
The mains plug is the disconnect device and therefore must remain readily operable.
(BS1362) approvals, these are easily identifiable by either the
or
symbols. If you are in any doubt about the installation of an extension lead, please consult a
competent electrician.
This symbol means that this unit is double insulated. An earth connection is not required.
CAUTION
To prevent electric shock, do not remove the cover. No user servicable parts inside. Refer servicing to
qualified service personnel. Disconnect from the mains supply before cleaning.

SAFETY PRECAUTIONS

Power Source.
This unit should only be connected to a 220-240V AC 50-60 Hz power supply. Do not connect to any
other supply.
Power Lead.
Do not place the lead where it may be stepped on or tripped over. Do not place heavy objects on the
lead. If the lead becomes cut or damaged, please disconnect the unit from the mains supply.
The mains plug or the appliance coupler is used as the disconnect device, the disconnect device shall
remain readily operable.
Location.
Place on a solid base such as a shelf or in a TV cabinet or similar. Do not place near heat sources
such as radiators, fires or similar.
Do not block ventilation holes or place in a location that does not allow a free airflow.
Do not place the unit near water or in high humidity areas. Avoid splashing. If the unit does get wet
please call an approved service agent.
Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases,
shall be placed on the apparatus.
7

Advertisement

Table of Contents
loading

Table of Contents