7. Preparing for the remote control
The accessory remote control needs batteries. Use the batteries
included in this product or two new batteries of the specified
type: HITACHI MAXELL , part number LR6 or R6P . Follow
the following procedure.
Remove the battery cover in the back of the remote
1.
control.
Put the batteries into the battery holder, according to the
2.
polarity markings (+) and (-) inside the holder.
Put the battery cover back to the former state.
3.
NOTE
malfunctions.
on the projector using infrared light (Class 1 LED).
The active sensor senses the remote control signal
assigned within 60 degrees to right and left, and
within 3 meters. For details, see the Operating
Guide in the CD.
strong ray. It may cause malfunction of the projector
and remote control.
WARNING
which could result in a fire, an injury, and environment pollution.
the battery holder, replace the batteries after wiping the leakage out.
battery to a fire or water.
Remote sensors
30º
30º
3 m
7