Hitachi VT-FX980EUKN Instruction Manual page 97

Pre-Tuning the Built in Tuner
Mis-Operation of Auto Install
In the case of mis-operation on the Auto Install on page 3 and page 4, please follow the procedure of pre-
tuning as shown below.
Controls
1 Turn on the TV and the VCR, then tune the TV to the video programme number.
If you connect the VCR and TV using a 21-pin Scart connector lead, select the 21-pin Scart input of the TV.
2
VIDEO LINK
COMMERCIAL ADVANCE
CA
VIDEO LINK
3
OPERATE VCR/TV AUX
PROG
PROG
4
TV
PROG
MENU MOVIE TEXT
NAVI
CA
MENU
Cursor
ENTER
REC INDEX
O LINK
COMMERCIAL ADVANCE
VIDEO LINK CA
5
VIDEO LINK
COMMERCIAL ADVANCE
VIDEO LINK CA
6
COMMERCIAL ADVANCE
PROG
7
COMMERCIAL ADVANCE
REC/
IRT
PROG
K
COMMERCIAL ADVANCE
VIDEO LINK CA
TV Screen
M E N U
REV I EW CH M DE O
N V I A S T A
PROG
SELECT OK MENU
C H P R E S ET
AUTO
M A N UAL
NICAM –
SELECT OK MENU
AUTO
MENU
REC
PROG IRT
PROG
Press the PLAY/STILL button.
The test pattern will disappear and the VCR change to the operate mode.
REV FWD
TAPE
NAVIGATION
REC/
IRT
Press the PROG
REV
FWD
Note: If no channels have been set or a clear picture does not appear,
TAPE
NAVIGATION
check the aerial or scart connection.
Note: When the pre-tuning of a channel is completed, the current time will
appear in the VCR display. This is because the auto clock setting function
has operated and the VCR clock has been set automatically. (See page 19
REC/
IRT
PROG
for details.)
Press the MENU button.
The menu, as illustrated, appears on the TV screen.
Exit
Press the cursor button to select the CH option, and
press the ENTER button.
The CH PRESET display, as illustrated, will appear on the
TV screen.
Exit
Press the ENTER button to select AUTO.
The display, as illustrated will appear on the TV screen
and " " will appear in the VCR display.
The VCR will start auto tuning, auto channel mapping,
auto clock setting, and auto RF seek function. It takes
about 3 minutes.
= Exit
The following stations are stored in programme
numbers 01 — 05 automatically.
01 BBC1
02 BBC2
03 ITV
04 CH4 (or S4C)
05 CH5
Note: If the station does not transmit a signal which
identifies itself, the station name will not appear.
Tune your TV (consult your TV instruction manual). The
correct tuning position is when the picture is clear.
After this process is complete, the test pattern will
appear on the TV screen, and the RF output channel will
appear in the VCR display.
5/∞
( )
buttons to check the channels you can receive.
– 5 –