Table of Contents
Advertisement
Configuring the Fast Ethernet Interfaces*
To determine which type of interfaces are installed on an FEIP in your system, use the
show diag slot command. Specific interface information is displayed, as shown in the following
example of an FEIP in interface processor slot 2:
In the preceding example, the two interfaces on the FEIP are clearly marked 100BaseTX.
For additional Fast Ethernet command descriptions and examples, refer to the publications listed in
the section "If You Need More Information" on page 2.
36 Fast Ethernet Interface Processor (FEIP) Installation and Configuration
Router# show diag 2
Slot 2:
Physical slot 2, ~physical slot 0xD, logical slot 2, CBus 0
Microcode Status 0x4
Master Enable, LED, WCS Loaded
Board is analyzed
Pending I/O Status: None
EEPROM format version 1
FEIP controller, HW rev 2.4, board revision D0
Serial number: 03700746
Test history: 0x00
Flags: cisco 7000 board; 7500 compatible
EEPROM contents (hex):
0x20: 01 20 02 04 00 38 78 0A 49 06 94 03 00 00 00 00
0x30: 68 00 00 03 00 00 00 00 00 00 00 00 00 00 00 00
Slot database information:
Flags: 0x4
Controller Memory Size: 8 MBytes DRAM, 1024 KBytes SRAM
PA Bay 0 Information:
Fast-Ethernet PA, 1 ports, 100BaseTX-ISL
EEPROM format version 1\
HW rev 1.0, Board revision A0
Serial number: 04622911
PA Bay 1 Information:
Fast-Ethernet PA, 1 ports, 100BaseTX-ISL
EEPROM format version 1
HW rev 1.0, Board revision A0
Serial number: 03540609
Part number: 73-1684-03
RMA number: 00-00-00
Insertion time: 0x9B8 (00:17:10 ago)
Part number: 73-1688-03
Part number: 73-1688-03
Advertisement
Table of Contents
