Troubleshooting - Chicago Electric 94678 Installation And Operation Instructions Manual

refer to a small engine service manual for procedures not explained in this manual. if you are uncertain about your ability
to successfully and safely perform any procedure below, service should be performed by a qualified mechanic.
Maintenance type
1. Check Engine Oil Level
2. Inspect for damage
3. Wipe off outside with clean,
slightly moist cloth
1. Change Engine Oil
2. Clean Air Filter (69)
(Replace Filter as needed)
Clean Deposit Cup (76)
(Clean monthly in dusty areas)
Clean Spark Plug (44)
(Replace as needed)
Engine Overhaul
refer to a small engine service
manual for procedures.
to be performed only by a qualified
mechanic and includes:
1. Valve Clearance Check/Adjust
2. Clean Combustion Chamber
3. Clean Fuel Tank, Filter, and Supply
Line (replace filter and line as needed)
problem
Engine will not start
Engine is running, but
power is not being supplied
to outlets.
for technical questions, please call 1-800-444-3353.
SKU 94678
Maintenance cHart
before/
after each
use
X
service is

troublesHootinG

possible causes
1. Fuel Tank empty.
2. Fuel Valve(s) closed.
3. Choke not in proper start position.
4. ON/OFF Switch off.
5. Oil level low.
6. Spark Plug damaged, gapped incorrectly, or
connected improperly.
7. Mechanical/electrical problem.
1. Circuit Protection (59a, 53a) tripped. Pilot
Light (56a) will be off.
2. Electrical problem.
every 3
Monthly or
Months or
20 hours
50 hours
X X
X
1. Check fuel level at Fuel Meter (1a).
2. Put Valves (9a, 81) in ON position.
3. Move Choke Control left to start.
4. Turn switch to ON position.
5. Check engine oil level.
6. Check Spark Plug gap, condition, and
connection.
7. Have qualified mechanic inspect and repair.
1. Reduce electrical load and reset Circuit
Protection (53a).
2. Have a qualified technician service unit.
every 6
yearly or
Months or
300 hours
100 hours
X
X
X
probable solutions
X
X
X
X
Page 14