Ferrari 575M Superamerica Owner's Manual page 62

ABOUT YOUR VEHICLE
The symbol Q will appear on the multi-
function display.
The system will take a maximum of
20 minutes to complete the setting
3
procedure with the vehicle in motion.
If the difference in pressure between the
wheels on the same axle exceeds 0.4 bar,
the system will not calibrate.
If the system detects a pressure drop
during calibration, the relevant symbol
will appear on the multi-function display
(see on page 49).
62
Multi-function display scroll buttons
The multi-function display scroll buttons
can be activated only with the ignition
key in position II.
By default, the time is displayed on the
multi-function display on the instrument
panel.
Briefly press (less than 2 seconds) the
left-hand button R to sequentially switch
between the various functions shown on
the display:
• outside temperature
• LH front tyre pressure (FL)
• RH front tyre pressure (FR)
• RH rear tyre pressure (RR)
• LH rear tyre pressure (RL).
If one or more alarm symbols illuminate
on the multi-function display, briefly
press the LH button R
above mentioned functions, using the
same procedures, but in the following
sequence:
• clock
• outside temperature
Q
• LH front tyre pressure (FL)
• RH front tyre pressure (FR)
• RH rear tyre pressure (RR)
• LH rear tyre pressure (RL).
Press the left-hand button
(more than 2 seconds) to access the
programming mode, where you can
scroll the options by briefly pressing the
LH button R.
Four options are available:
• adjusting the instrument panel
brightness
• turning the clock ON/OFF
• setting the hours
• setting the minutes.
R
to access the
R at length
S